Power › Energy2 min read

DGIST builds bifacial antimony-based solar cell with polymer rear electrode; tandem reaches 12.32%

Researchers at DGIST built an antimony-based thin-film cell that absorbs light from both sides. Paired with a CuInSe₂ cell, the tandem reached an efficiency of up to 12.32%.

DGIST builds bifacial antimony-based solar cell with polymer rear electrode; tandem reaches 12.32%
Photo: Grendelkhan, Wikimedia Commons, CC BY-SA 4.0 · License: CC BY-SA 4.0

A research team led by Dae-Kue Hwang and Dae-Hwan Kim of the Division of Energy & Environmental Technology at DGIST in Daegu, South Korea, has developed a bifacial thin-film solar cell based on antimony, Sb₂(S,Se)₃, with a transparent polymer rear electrode, ResearchSEA reports. The device converts light entering from both the front and rear sides into electricity asiaresearchnews.comResearchSEAasiaresearchnews.comOpen source ↗. The findings were published in Advanced Materials.

Transparent rear electrode for bifacial cells

To raise the output of a solar cell, it helps to use not only direct sunlight but also light reflected and scattered by the ground and surrounding objects. Two approaches are considered promising for this: bifacial structures, which absorb light from both sides, and tandem structures, which stack two cells that absorb different wavelengths. A major obstacle to efficient bifacial operation has been the rear electrode. It must be highly transparent so that light passes through, and at the same time collect current efficiently.

The team made the rear electrode from several layers of specialized transparent conductive polymers deposited by a solution-based process. A specific additive, DMSO, was added to the polymer to control its electrical conductivity. According to the report, this reduced electrical resistance by a factor of 10,000 (four orders of magnitude) while keeping high optical transparency.

Efficiency of the single cell and the tandem

The resulting bifacial antimony-based cell reached a power conversion efficiency of 8.2% under front-side illumination and 3.3% under rear-side illumination asiaresearchnews.comResearchSEAasiaresearchnews.comOpen source ↗. The researchers also demonstrated a four-terminal tandem structure. The antimony-based cell was placed on top as the upper cell and combined with a CuInSe₂ cell as the lower cell; the two absorb light at relatively different wavelengths.

The tandem device reached a power conversion efficiency of up to 12.32%. When the front and rear sides were illuminated simultaneously at 1 sun each, its bifacial power density was 18.81 mW/cm². According to the authors, this shows that the device can convert scattered light reflected from its surroundings into electricity.

The authors state that the study demonstrates the feasibility of bifacial power generation with antimony-based cells and their potential for integration into tandem cells through the new polymer rear electrode. As next steps, they plan to improve performance by optimizing the interface between the electrode and the light-absorbing layer, as well as the optical structure.

Sources · 1

Found a mistake?
  1. ↩

Read also

Up next

The next story opens automatically

More
Follow us

Type at least two letters — results appear instantly

↑↓to choose↵to openescto close