Machines › Materials2 min read

Novosibirsk State University patents a CO₂ sorbent regenerated at 90–100 °C; tested at 500 g scale

NSU received a patent for a low-temperature regenerable CO₂ absorber. Per the author, it holds up to 17% of its own mass in CO₂ and passed pilot tests in a 1-litre adsorber.

Novosibirsk State University patents a CO₂ sorbent regenerated at 90–100 °C; tested at 500 g scale
Photo: Научная Россия

Novosibirsk State University (NSU) has received a patent for a "low-temperature regenerable carbon dioxide absorber", according to Nauchnaya Rossiya. The author is Andrey Sheskovas, a research engineer at the NSU Center for New Functional Materials. The material is intended to capture CO₂ from gas mixtures, including industrial flue gas and biogas. scientificrussia.ruНаучная Россияscientificrussia.ruOpen source ↗

After saturation, the sorbent can be heated, the carbon dioxide extracted, and the material reused for gas purification. According to the developer, it can retain up to 17% of its own mass in CO₂.

Composition and regeneration

The absorber is a composite of a porous support and an active component. The support is a meso-macroporous polymer matrix based on a styrene–divinylbenzene (SDVB) copolymer. Mesopores distribute the active component, while macropores serve as transport channels for CO₂. In the patented formulation SDVB makes up 50–80% of the mass, and the remainder is PEI.

Sheskovas stated that the material can be heated to 90–100 degrees and its properties fully restored. During regeneration the CO₂ is released rather than destroyed. The recovered gas can be sent for conversion into useful products or for storage, depending on the emitting enterprise. scientificrussia.ruНаучная Россияscientificrussia.ruOpen source ↗

Synthesis and testing

Per the author, synthesis is simple: an alcohol solution of the active component is added to the porous matrix, followed by drying.

The team recently scaled up the synthesis from the 1 g typical of laboratory work to 500 g. The material then underwent pilot tests in an adsorber with a 1-litre working volume. According to the developer, no decline in sorption characteristics was observed.

The development has not yet reached industrial use, and the team is looking for industrial partners. A scientific paper on the material is in preparation. Further work should show how the absorber performs in the transition from a test installation to treating gas streams at enterprises. scientificrussia.ruНаучная Россияscientificrussia.ruOpen source ↗

The information was provided by the NSU press service.

Sources · 1

Found a mistake?
  1. ↩

Read also

Up next

The next story opens automatically

More
Follow us

Type at least two letters — results appear instantly

↑↓to choose↵to openescto close