Co-free Ni-rich cathode with descriptor-selected dopants keeps 82.4% capacity after 350 cycles
Researchers chose dopants for a cobalt-free nickel-rich lithium-ion cathode by charge density and bond strength; the material was tested in the laboratory, including at −20 °C.

A research group at the Chinese Academy of Sciences has reported a method for choosing dopants for cobalt-free, nickel-rich layered oxide cathodes of lithium-ion batteries. The paper, published in Nature Synthesis and available via doi.org, describes a descriptor-informed selection of several dopants at once nature.com
doi.orgnature.comOpen source ↗. In laboratory tests the material delivered 130.9 mAh g−1 at 25 C and retained 82.4% of its capacity after 350 cycles at 10 C.
Dopant selection by two descriptors
Cobalt-free nickel-rich cathodes are considered a route to cost-effective, high-energy lithium-ion batteries. Their practical use is limited by sluggish Li+ kinetics and rapid capacity fading. Doping is widely used against both problems, but the choice of dopants has mostly been made by trial and error, which the authors describe as inefficient.
The authors based the selection on two descriptors: dopant charge density and metal–oxygen bond strength. Dopants with low charge density reduce electrostatic barriers to Li+ migration. Dopants with high bond energy reinforce the oxygen sublattice and stabilize the metal–oxygen framework. According to the publication's summary, magnesium and calcium were chosen to ease lithium movement, and titanium and zirconium to strengthen the oxygen framework.
Rate, cycling and low-temperature results
The authors report that this combination accelerates Li+ kinetics, suppresses phase transitions during cycling and mitigates chemomechanical fatigue nature.com
doi.orgnature.comOpen source ↗. The measured values were 130.9 mAh g−1 at 25 C and 82.4% retention after 350 cycles at 10 C. At −20 °C and 1 C the cathode delivered 112.2 mAh g−1.
These figures come from experimental materials and cells under specific test conditions, not from finished commercial batteries. They do not show how an electric car would charge or how far it would travel. Long-term safety, manufacturing cost and performance in complete battery systems remain to be established.
The authors present the main outcome as a change in design principle: from empirical, trial-based dopant selection to a targeted one, based on measurable chemical properties.



