# Tunable plasma photonic crystals in barrier discharge: lattice and bandgap switched by voltage

- Published: 2026-11-16 02:52 UTC
- Section: Science › Physics
- Tags: plasma photonic crystal, dielectric barrier discharge, tunable photonic crystal, photonic bandgap, Dirac cones, Moiré lattice, topological interface, Kagome lattice, microwave transmission
- URL: https://realtech.media/news/rt-744fd491659eb021409c2ec8_tunable_plasma_photonic/

**A team led by Jing Wang and Xiaoyong Hu built a laboratory dielectric barrier discharge setup whose plasma lattices are reconfigured by voltage, shifting microwave bandgaps.**

![Tunable plasma photonic crystals in barrier discharge: lattice and bandgap switched by voltage](https://realtech.media/media/2026/11/ec47508be50a623d.jpg)
*NASA, Wikimedia Commons, Public domain*

A research team led by Jing Wang, Shuang Liu, Weili Fan and Xiaoyong Hu has demonstrated a laboratory platform that produces tunable plasma photonic crystals in dielectric barrier discharge, according to a paper in Frontiers of Optoelectronics [1]. The setup controls five structural parameters: symmetry, dielectric constant, crystal orientation, lattice constant and the structure of individual scattering elements [1]. The authors also report switching between non-topological and topological lattice states [1].

## Discharge setup and lattice transitions

One side of the discharge cell is a water electrode: an 80-millimeter-inner-diameter container with tap water, sealed with glass plates 0.5 to 2 millimeters thick. The other side is an interchangeable metal mesh electrode, driven by a sinusoidal source of up to 10 kilovolts and 0 to 80 kilohertz, separated from the water by a 1 to 4 millimeter quartz frame. Micro-discharge filaments self-organize into two-dimensional arrays with electron densities of 10^13 to 10^15 per cubic centimeter [1].

With a honeycomb mesh (lattice constant 8.66 millimeters) in air at 114 Torr and 50 kilohertz, raising the voltage from 3.2 to 5.0 kilovolts turned a simple honeycomb lattice into a series of superlattices [1]. The first omnidirectional bandgap, measured in the microwave range, moved from 23.5 to 26.7 gigahertz for the baseline lattice to 37.7 to 47.0 gigahertz for superlattice IV [1]. Dirac cones at the K point were identified in superlattices II, III and IV [1].

## Disorder, Moiré patterns and topology

With a Kagome mesh (8 millimeters), voltage steps produced alternating disordered and ordered states. A Kagome lattice at 3.7 kilovolts showed a bandgap of 27.3 to 33.6 gigahertz, and an ordered honeycomb superlattice at 4.1 kilovolts showed 44.8 to 55.1 gigahertz [1].

Moiré lattices were produced by rotating two identical meshes against each other. Striped arrays with 10-millimeter spacing were tested in an argon-air mixture at 190 Torr, and square and honeycomb arrays at 152 Torr; rising voltage turned basic interference patterns into multi-scale superlattices [1].

For the topological case, selected mesh nodes were covered with polytetrafluoroethylene film. In an argon-to-air mixture of 3 to 2 at 135 Torr and 3.6 kilovolts, the open nodes gave triangular plasma elements with 3.0-millimeter sides, oriented at either negative or positive 30 degrees [1]. The elements fired synchronously within one 350-nanosecond current pulse per half-period, with jitter below 30 nanoseconds [1]. Joining domains of opposite orientation produced Line-type, Z-type and Omega-type interfaces [1].

## Sources

1. [Frontiers of Optoelectronics](https://doi.org/10.1007/s12200-024-00137-z)
2. [bioengineer.org](https://bioengineer.org/tunable-plasma-photonic-crystals-enable-dynamic-control-over-topology-and-electromagnetism)

---

Source: RealTech, realtech.media — https://realtech.media/news/rt-744fd491659eb021409c2ec8_tunable_plasma_photonic/
